Diskless X Server: a how to guide

Jerry Kendall

    
  

28-December-1996

With the help of some friends on the FreeBSD-hackers list, I have been able to create a diskless X terminal. The creation of the X terminal required first creating a diskless system with minimal utilities mounted via NFS. These same steps were used to create 2 separate diskless systems. The first is altair.example.com. A diskless X terminal that I run on my old 386DX-40. It has a 340Meg hard disk but, I did not want to change it. So, it boots from antares.example.com across a Ethernet. The second system is a 486DX2-66. I set up a diskless FreeBSD (complete) that uses no local disk. The server in that case is a Sun 670MP running SunOS™ 4.1.3. The same setup configuration was needed for both.

I am sure that there is stuff that needs to be added to this. Please send me any comments.


1 Creating the boot floppy (On the diskless system)

Since the network boot loaders will not work with some of the TSR's and such that MS-DOS® uses, it is best to create a dedicated boot floppy or, if you can, create an MS-DOS menu that will (via the config.sys/autoexec.bat files) ask what configuration to load when the system starts. The later is the method that I use and it works great. My MS-DOS (6.x) menu is below.

Example 1. config.sys

[menu]
menuitem=normal, normal
menuitem=unix, unix
[normal]
....
normal config.sys stuff
...
[unix]

Example 2. autoexec.bat

@ECHO OFF
goto %config%

:normal
...
normal autoexec.bat stuff
...
goto end

:unix
cd \netboot
nb8390.com

:end

This, and other documents, can be downloaded from ftp://ftp.FreeBSD.org/pub/FreeBSD/doc/.

For questions about FreeBSD, read the documentation before contacting <questions@FreeBSD.org>.
For questions about this documentation, e-mail <doc@FreeBSD.org>.