There are several options which can be set for any jail, and various ways of combining a host FreeBSD system with jails, to produce higher level applications. This section presents:
Some of the options available for tuning the behavior and security restrictions implemented by a jail installation.
Some of the high-level applications for jail management, which are available through the FreeBSD Ports Collection, and can be used to implement overall jail-based solutions.
Fine tuning of a jail's configuration is mostly done by setting sysctl(8) variables. A
special subtree of sysctl exists as a basis for organizing all the relevant options: the
security.jail.* hierarchy of FreeBSD kernel options. Here is
a list of the main jail-related sysctls, complete with their default value. Names should
be self-explanatory, but for more information about them, please refer to the jail(8) and sysctl(8) manual
pages.
security.jail.set_hostname_allowed: 1
security.jail.socket_unixiproute_only: 1
security.jail.sysvipc_allowed: 0
security.jail.enforce_statfs: 2
security.jail.allow_raw_sockets: 0
security.jail.chflags_allowed: 0
security.jail.jailed: 0
These variables can be used by the system administrator of the host system to add or remove some of the
limitations imposed by default on the root user. Note that
there are some limitations which cannot be removed. The root
user is not allowed to mount or unmount file systems from within a jail(8). The root inside a jail may not load or unload devfs(8) rulesets, set
firewall rules, or do many other administrative tasks which require modifications of
in-kernel data, such as setting the securelevel of the
kernel.
The base system of FreeBSD contains a basic set of tools for viewing information about the active jails, and attaching to a jail to run administrative commands. The jls(8) and jexec(8) commands are part of the base FreeBSD system, and can be used to perform the following simple tasks:
Print a list of active jails and their corresponding jail identifier (JID), IP address, hostname and path.
Attach to a running jail, from its host system, and run a command inside the jail or perform administrative tasks inside the jail itself. This is especially useful when the root user wants to cleanly shut down a jail. The jexec(8) utility can also be used to start a shell in a jail to do administration in it; for example:
# jexec 1 tcsh
Among the many third-party utilities for jail administration, one of the most complete and useful is sysutils/jailutils. It is a set of small applications that contribute to jail(8) management. Please refer to its web page for more information.
This, and other documents, can be downloaded from ftp://ftp.FreeBSD.org/pub/FreeBSD/doc/.
For questions about FreeBSD, read the documentation before contacting <questions@FreeBSD.org>.
For questions about this documentation, e-mail <doc@FreeBSD.org>.