2.5. Parallelism

PMake was specifically designed to re-create several targets at once, when possible. You do not have to do anything special to cause this to happen (unless PMake was configured to not act in parallel, in which case you will have to make use of the -L and -J flags (see below)), but you do have to be careful at times.

There are several problems you are likely to encounter. One is that some makefiles (and programs) are written in such a way that it is impossible for two targets to be made at once. The program xstr, for example, always modifies the files strings and x.c. There is no way to change it. Thus you cannot run two of them at once without something being trashed. Similarly, if you have commands in the makefile that always send output to the same file, you will not be able to make more than one target at once unless you change the file you use. You can, for instance, add a $$$$ to the end of the file name to tack on the process ID of the shell executing the command (each $$ expands to a single $, thus giving you the shell variable $$). Since only one shell is used for all the commands, you will get the same file name for each command in the script.

The other problem comes from improperly-specified dependencies that worked in Make because of its sequential, depth-first way of examining them. While I do not want to go into depth on how PMake works (look in Chapter 4 if you are interested), I will warn you that files in two different levels of the dependency tree may be examined in a different order in PMake than they were in Make. For example, given the makefile:

a               :

b c b           : d

PMake will examine the targets in the order c, d, b, a. If the makefile's author expected PMake to abort before making c if an error occurred while making b, or if b needed to exist before c was made, (s)he will be sorely disappointed. The dependencies are incomplete, since in both these cases, c would depend on b. So watch out.

Another problem you may face is that, while PMake is set up to handle the output from multiple jobs in a graceful fashion, the same is not so for input. It has no way to regulate input to different jobs, so if you use the redirection from /dev/tty I mentioned earlier, you must be careful not to run two of the jobs at once.

This, and other documents, can be downloaded from ftp://ftp.FreeBSD.org/pub/FreeBSD/doc/.

For questions about FreeBSD, read the documentation before contacting <questions@FreeBSD.org>.
For questions about this documentation, e-mail <doc@FreeBSD.org>.